Siemens ET 200SP analog input module, 6ES7134-6JF00-2CA1, 15 mm width, RTD and thermocouple support, 15/16-bit resolution, current lifecycle.
| Parameter | Value |
|---|---|
| Number of analog inputs | 8 |
| Input range: -80 to +80 mV | Yes; 16 bit incl. sign |
| Input range: 0 to 600 Ohm | Yes; 15 bit |
| RTD type: Pt100 | Yes; 16 bit incl. sign |
| RTD type: Pt200 | Yes; 16 bit incl. sign |
| Permissible input voltage, max. (destruction limit) | 30 V |
| Max. shielded signal cable length | 200 m; 50 m with thermocouples |
| Parameter | Value |
|---|---|
| Resolution (bit incl. sign), max. | 16 bit |
| Measurement principle | integrating (Sigma-Delta) |
| Temperature measurement error (±) | 0.0009 %/K; ±0.005 % / K at thermocouple |
| Voltage measurement error (±) | 0.05 % |
| Interference voltage suppression (at interference frequency) | 16.6 / 50 / 60 Hz |
| Common-mode interference suppression, min. | 90 dB |
| Common-mode voltage, max. | 10 V |
| Parameter | Value |
|---|---|
| Wire-break detection | Yes; channel by channel |
| Diagnostic alarm | Yes |
| Diagnostics function | Yes |
| Limit value alarm | Yes; two upper and two lower limit values in each case |
| Supply voltage monitoring | Yes |
| Parameter | Value |
|---|---|
| Isolation: channels to backplane bus | Yes |
| Isolation: between channels | No |
| Isolation test voltage | 707 V DC (type test) |
| Parameter | Value |
|---|---|
| Rated value (DC) | 24 V |
| Power loss, typ. | 0.75 W |
| Reverse polarity protection | Yes |
| Parameter | Value |
|---|---|
| Operating temperature, horizontal mounting, max. | 60 °C |
| Operating temperature, horizontal mounting, min. | -30 °C; < 0 °C as of FS05 |
| Operating temperature, vertical mounting, max. | 50 °C |
| Operating temperature, vertical mounting, min. | -30 °C; < 0 °C as of FS05 |
| Parameter | Value |
|---|---|
| Width | 15 mm |
| Height | 73 mm |
| Depth | 58 mm |
The 6ES7134-6JF00-2CA1: Wire-break detection is per channel, and a group-error signal is available for fast fault isolation. I&M data (I&M0 through I&M3) is supported for asset tracking. Note: Module-specific interrupt (MSI) is not supported, and there is no oversampling.
Width is 15 mm, height 73 mm, depth 58 mm — the standard ET 200SP slim footprint. Shielded cable runs up to 200 m; thermocouples are limited to 50 m.
No, MSI is not supported on this module.
PTC input resolution is 15-bit.
No related articles