The Siemens 6ES7151-1BA02-0AB0 is the SIMATIC DP interface module IM151-1 High Feature, acting as the PROFIBUS DP head-end for an ET 200S distributed I/O station — the part that takes the DP cable from the master and exposes the backplane bus to up to 63 plugged-in I/O modules. Bus connection is via a 9-pin D-sub and the termination module is included in the package, so the segment terminator is not a separate line item at commissioning. Lifecycle stage is recorded as current on this order code.
PROFIBUS DP side — what the master sees
Transmission runs RS 485, PROFIBUS DP, with a maximum transmission rate of 12 Mbit/s — set the master port to the same baud and the segment length per the PROFIBUS cable table. Each direction carries up to 244 bytes of I/O data; the station supports direct data exchange (slave-to-slave communication), so a second DP slave can be a publisher to this node without a master round-trip. Electronics are isolated from the PROFIBUS DP segment; isolation is tested with 500 V DC.
Backplane sizing and I/O capacity
Up to 63 ET 200S modules can be connected behind the interface, with 244 bytes of inputs and 244 bytes of outputs as the address-volume ceiling per station.
Power and supply behavior
From supply voltage 1L+ the module draws up to 200 mA, with a typical power loss of 3.3 W. Mains/voltage failure stored energy time is 20 ms. There is no isolation between the supply voltage and the electronics, and no isolation between the backplane bus and electronics either; segregation against PROFIBUS DP is the only galvanic barrier on this module.
Panel-side envelope and approvals
Footprint on the DIN rail is 45 mm wide, 119.5 mm high, 75 mm deep; operating envelope is 0 °C to 60 °C. CE mark and UL approval are both recorded on this code, so it ships into a UL-listed panel build without a separate approval loop on the BOM line.