The 6ES7195-0BD02-0XA0 is a Siemens ASIC SPC3 — a dedicated PROFIBUS DP protocol controller in a PQFP 44-pin package. It handles the full DP data link layer in hardware, offloading the host microprocessor. The bus access is integrated into the ASIC, and it supports automatic baud rate detection up to 12 Mbit/s. Telegram memory sits at 1.5 kbyte. Designed for intelligent slave applications, not for use as a standalone module. Operating range covers -40 °C to 85 °C, powered from a 5 V DC rail with a maximum power loss of 0.5 W. Firmware scope of 4 to 24 KB gives flexibility for the host code. Delivery is in multiples of 5 pieces per plastic tray.
The 12 Mbit/s transmission rate is the maximum baud rate for PROFIBUS DP, but the ASIC automatically detects the actual bus speed, so it handles mixed-segment installations without manual configuration. The 1.5 kbyte telegram memory determines the maximum data throughput per cyclic message; keep your process data within that limit or the ASIC will buffer across multiple DP cycles. Host microprocessor requirement is one — the SPC3 does not contain a CPU; it sits on the bus as a peripheral controller driven by your own MCU via parallel interface. Power draw is minimal: 0.5 W max from a 5 V supply. That keeps thermal load low in dense PCB layouts. The PQFP 44-pin housing is a standard footprint; verify your reflow profile for the 2 cm² body size.