Skip to main content
Siemens 3RK1301-0FB00-0AA2

Siemens 3RK1301-0FB00-0AA2 SIMATIC Motor Starter, CLASS 10,

MPN 3RK1301-0FB00-0AA2

Siemens SIMATIC motor starter, direct starter, 3RK1301-0FB00-0AA2, 24 V DC, CLASS 10, 50 kA at 400 V, PROFINET/PROFIBUS DP.

$411.48 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

3RK1301-0FB00-0AA2 specifications
ParameterValue
Mountingpluggable on terminal module
Depth120 mm
Width45 mm
Height265 mm
Trip classCLASS 10

Product details

SIMATIC direct starter — 3RK1301-0FB00-0AA2

The Siemens 3RK1301-0FB00-0AA2 is a SIMATIC direct starter motor starter, designed for direct-on-line starting of three-phase motors. The unit is pluggable on a terminal module, so it swaps without disturbing the power wiring.

Rated 50 kA at 400 V — that is the short-circuit breaking capacity at the main incoming supply level. For a panel fed from a 400 V transformer with an SCCR requirement above 50 kA, this starter coordinates cleanly without needing upstream fuses to clip the fault current. The 24 V DC control supply (20.4 to 28.8 V range) is standard for modern PLC cabinets; the unit pulls its logic power from the same 24 V bus as the rest of the SIMATIC I/O. Operating frequency is rated at a maximum of 750 1/h — that is about one start every 4.8 seconds. Fine for most conveyor and fan duty; not suited for high-cycle indexing or rapid reversing (reverse starting is explicitly not supported). Mounting is vertical or horizontal, and the 45 mm width and 120 mm depth fit standard 45 mm DIN-rail spacing.

Network integration — PROFINET and PROFIBUS DP

This starter supports both PROFINET and PROFIBUS DP protocols natively. The digital I/O map is 1 byte input and 1 byte output — enough for start/stop feedback, fault status, and a few diagnostic bits. No additional gateway or communication module is needed; it connects directly to the PLC via the network cable.

Shock resistance is 5 g for 11 ms, vibration resistance 2 g — suitable for panel mounting in industrial environments with moderate vibration. Degree of pollution is 3 at 400 V and 2 at 500 V per IEC 60664, which covers most factory floor conditions (conductive dust, occasional condensation).

MPN
3RK1301-0FB00-0AA2