The ABB 1SFA899215R1080 is a PSFA-80 fan, a forced-air cooling unit designed for mounting inside ABB drive cabinets and control panels. It's the active-production version of this fan family — lifecycle status is current, so ABB is still manufacturing it and supporting it on new builds. RoHS compliance follows EU Directive 2011/65/EU and Amendment 2015/863, making it suitable for European markets without exemption paperwork. It's classified as B2B and outside WEEE scope, so no end-of-life recycling fee applies at purchase.
No direct replacement or cross-reference part is listed, which is typical for an active fan where the manufacturer intends the current order code to be the sole supply path. If you're swapping an older PSFA variant, verify the mounting hole pattern and connector type against your cabinet — the PSFA-80 form factor is consistent, but always check the dimensional drawing (2CDC001079B0201) against your panel cutout.
Installation notes
Mounts inside the cabinet, typically on the door or rear panel, to push or pull air through the drive heat sink. The PSFA-80 is a standard 80 mm frame fan — confirm the airflow direction arrow matches your cabinet's thermal design before final tightening.