The ABB 3ABD00048322-D is an ACS580-01 wall-mounted general-purpose drive rated for 200 kW normal use at 363 A output, with heavy-duty capability of 160 kW at 293 A. It runs on 380–500 V three-phase input, 47.5–63 Hz, so it handles 50 Hz and 60 Hz mains without a line reactor swap. Frame size R9 and IP21 / NEMA Type 1 enclosure mean it goes on a wall indoors — no extra shelter needed, but keep it out of washdown zones.
The two current ratings matter differently. Normal-use 363 A (200 kW) is your continuous motor load at rated speed. Heavy-duty 293 A (160 kW) is what the drive can deliver for constant-torque or high-start-torque applications — conveyors, crushers, extruders. If your motor plate says 200 kW but the load is a screw feeder that starts loaded, size against the 293 A heavy-duty figure, not the headline 363 A. Light-overload rating 345 A (200 kW) sits between them, covering pumps and fans with moderate starting torque.
Wall-mounted, frame R9. IP21 keeps out fingers and falling dust — fine for a clean electrical room, not for outdoor or wet areas. NEMA Type 1 equivalent. No DIN-rail option at this frame; it bolts to a backplate. Plan for cable entry from the bottom or side through the gland plate. The drive is large equipment per WEEE Category 4, so factor end-of-life recycling into your compliance paperwork.