The ABB 3AXD50000418152 is a wall-mounted drive rated for 7.5 kW normal use and 31.2 A output current on a 200...240 V three-phase supply. It is built for water and wastewater applications, with an IP55 enclosure and NEMA Type12 rating. Frame size R2, and it includes the control unit.
Ratings that matter on the route
Normal-use output is 31.2 A at 7.5 kW, but if you've got a tough load — say a pump that cycles hard — the heavy-duty rating drops to 24.2 A at 5.5 kW. That's the number to size by when the motor sees repeated starts or a heavy slug. Light-overload use sits at 30.8 A, still 7.5 kW, so you've got a bit of headroom between normal and heavy. Efficiency is IE2, and the power factor sits at 0.98, so the utility meter won't spin any faster than it has to. Standby loss is 14 W, sound level 64 dB(A) — about as loud as a quiet conversation, so it won't bother anyone in a MCC room. The drive handles altitudes up to 4000 m without derating, and ambient temperature maxes at 40 °C. Humidity range is 5 to 95%, so condensation in a wet well won't phase it.
I/O and comms for the controls guy
You get 2 analog inputs and 2 analog outputs, plus 6 digital inputs and 3 digital outputs. That's enough for a basic pump setup — feedback from a pressure transmitter, start/stop, and a run status back to the PLC. Communication is CAN protocol, not Ethernet, so if you need to talk to a modern controller you'll want a gateway or a different drive variant. No industrial Ethernet interface onboard. The drive includes a CR2032 lithium coin cell (220 mAh, 3 V) for backup. Frequency range is 47.5 to 63 Hz.