What you're looking at
The ABB ACH580-VCR-07A6-4 is an ACH580-series wall-mount AC drive in the ABB Drives line, catalogued under Motor Drives. The "VCR" suffix in the order code denotes the standard wall-mount form factor used across the ACH580 HVAC / general-purpose family, which is the version a panel builder usually lands on when the spec calls out ACH580 rather than the drive's larger cabinet siblings. Listed weight is 13.61 kg for the bare drive — a one-person lift but worth planning the enclosure pull-and-set before the wiring harness lands, because the cable glands sit on the bottom and the drive is easier to terminate on the bench than overhead.
Sizing and where it sits in the family
The peer listing ACH580-VCR-027A-4 shares the same 13.61 kg weight and form factor, so it is a same-frame upsize if the motor turns out larger than the original estimate.
Application fit
Catalogued under Motors & Motor Controls, Drives, Motor Drives; typical fit is fans, pumps, and small compressors in HVAC and water/wastewater panels where the duty cycle keeps the motor well inside its thermal curve. Wall-mount installation: mount vertically with the cable entry down, leave the clearances called out in the ABB manual around the heatsink fins, and keep motor cable length inside the drive's stated limit for the switching frequency used — long motor cables with no output filter will push reflected-wave voltage high enough to stress winding insulation on standard inverter-duty motors. If the run forces a long pigtail, plan a dV/dt or sinus filter ahead of the motor rather than hoping the insulation holds.
Sourcing posture
Peer MPN ACH580-VCR-027A-4 matches the same 13.61 kg form factor; the ACH580-PDR-027A-4+B056 is listed at 16.33 kg as a higher-IP alternative rather than a same-rating swap. No official successor code is on record for the 07A6-4.