Skip to main content
ABB 1SFA894011R7020

ABB PST175 1SFA894011R7020 Softstarter, 175 A In-Line, 90 kW

MPN 1SFA894011R7020
Obsolete

ABB PST175 series softstarter, order code 1SFA894011R7020, 175 A in-line rated operational current (Ie), 90 kW at 400 V, 0–120 s adjustable ramp time, built-in electronic overload protection.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

1SFA894011R7020 specifications
ParameterValue
Terminal typeMain Circuit: Bars
VoltageMain Circuit 208 ... 600 V AC
Frequency50/60 Hz
ProtocolFiledBusPlug(Standard)
Temp operating max50 °C
Temp operating min0 °C

Product details

The ABB PST175 1SFA894011R7020 is a softstarter sized for a 175 A in-line motor load — that's 90 kW at 400 V. If you're wiring it inside-delta, it carries 300 A / 160 kW at 400 V, which is the configuration for larger motors where the starter sees phase current instead of line current. The built-in electronic overload protection eliminates the need for a separate overload relay on the BOM — one device handles starting and protection. Ramp time is adjustable from 0 to 120 seconds, and the initial voltage during start sits between 30 and 70 % with a step-down special ramp from 100 to 30 %. That range covers soft starting for high-inertia loads like conveyors or fans, and soft stopping for pumps to avoid pressure surges. Control supply voltage is 100–250 V AC, with a separate 24 V DC control circuit for the logic side — keeps the control wiring isolated from the power circuit. The unit includes run, fault, by-pass, and overload signal relays, so you get status feedback without adding interface modules.

Deployment context

Main terminals are IP00 per IEC 60529 — that means the power connections are bare bus bars, intended for enclosure mounting where the panel provides the overall IP rating. The main circuit connects via bars with a 10.2 mm hole diameter; control wiring uses rigid 1 x 2.5 mm² terminals with a 0.5 N·m tightening torque. Communication is via a standard FieldBusPlug, which means it accepts the ABB fieldbus adapter modules for PROFIBUS, DeviceNet, or similar — no onboard protocol, but ready for a plug-in gateway.

MPN
1SFA894011R7020