Skip to main content
ABB 1SFA898104R7000

ABB 1SFA898104R7000 PSTX37 Soft Starter, 208-600 VAC

MPN 1SFA898104R7000
Active

ABB PSTX37 soft starter, 1SFA898104R7000, 208-600 VAC, 50/60 Hz, auto phase sequence detection, ramp time 1-120 s, Modbus-RTU/TCP, Ethernet/IP, EtherCAT, Profinet, DeviceNet, CANopen, Profibus, BACnet-IP/MSTP, built-in electronic overload, IP00 main terminals.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

1SFA898104R7000 specifications
ParameterValue
Terminal typeCable Clamp
Voltage208 ... 600 V AC
Frequency50/60 Hz
Temp operating max60 °C
Temp operating min-25 °C

Product details

PSTX37 — fieldbus-ready soft starter with auto phase sequence

The ABB 1SFA898104R7000 is a PSTX37 soft starter rated for 208 to 600 V AC at 50/60 Hz, with a built-in electronic overload and auto phase sequence detection that protects the motor during commissioning — no separate phase monitor needed. Ramp time is adjustable from 1 to 120 seconds, covering most induction-motor start profiles from low-inertia fans to high-inertia conveyors. Control supply is 100 to 250 V AC; the control circuit itself runs on 24 V DC, so the PLC or safety relay can drive it directly without an interposing relay. The main terminals accept cable clamp connections with an 8.5 mm hole and a tightening torque of 8 N·m.

Protection and warnings — what is covered

This soft starter includes built-in electronic overload protection with dual overload curves — separate settings for start and run — plus earth fault / ground fault protection, locked rotor protection, phase reversal protection, overvoltage and undervoltage protection, and voltage imbalance protection. It also accepts PTC thermistor inputs for direct motor temperature monitoring. Warning outputs cover current imbalance, underload, electronic overload time-to-trip, end-of-life, faulty fan, locked rotor, motor runtime limit, overvoltage, phase loss (standby), power factor underload, short circuit (limp mode), THD(U) harmonic distortion, thyristor overload, undervoltage, and voltage imbalance. Three signal relays (run, fault, bypass, overload) provide dry-contact status to the controller.

Fieldbus and analog interface

The PSTX37 supports Modbus-RTU, Modbus-TCP, Ethernet/IP, EtherCAT, DeviceNet, CANopen, Profibus, Profinet, BACnet-IP, and BACnet-MSTP — one unit covers nearly any plant-floor network without a separate gateway. Analog outputs are configurable for 0–10 V, 0–20 mA, or 4–20 mA, so the starter can feed a drive speed reference or a remote SCADA indication.

No last-time-buy or end-of-life notice applies.

MPN
1SFA898104R7000