Skip to main content
ABB 2CDS253103R0254

ABB 2CDS253103R0254 4-Pole MCB, C-Curve, 25 A, 6 kA

MPN 2CDS253103R0254

ABB System pro M compact S200 series, 4-pole MCB (DIN Rail), 2CDS253103R0254, C-curve, 25 A, 440 V, 6 kA Icn / 20 kA Icu, IP20 / IP40.

$24.13 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

2CDS253103R0254 specifications
ParameterValue
Insulation voltage ui440 V
Current25 A
Poles4
IP ratingIP20 / IP40
MountingDIN Rail
Depth69 mm
Width70 mm
Height88 mm

Product details

Line-down fit check — 25 A, C-curve, 4-pole

ABB 2CDS253103R0254 is a 4-pole miniature circuit breaker from the System pro M compact S200 series, rated 25 A with a C tripping characteristic. The C-curve means it trips between 5× and 10× rated current — standard for inductive and motor-start loads where inrush is higher than a resistive heater but lower than a transformer bank. Rated short-circuit breaking capacity Icn is 6 kA per IEC 60898, with an ultimate Icu of 20 kA per IEC 60947-2. The Icu figure tells you the breaker can safely clear a fault up to 20 kA once — the Icn is the service rating for repeated operation. For a distribution board fed from a transformer with a prospective short-circuit current under 6 kA, this breaker holds up across multiple faults without needing replacement after every trip.

What the 25 A and C-curve mean for a panel builder

The 25 A rating with a C-curve is sized for general lighting and socket-outlet circuits in commercial or light-industrial panels, or for motor branch circuits where the starting surge stays within 5–10× In. Rated insulation voltage is 440 V — the breaker fits three-phase 400 V systems with margin. Overvoltage category III means it's rated for fixed-installation distribution boards, not for equipment-level protection. Mounts on a DIN rail — snaps into the standard 35 mm profile. The bi-directional cylinder-lift terminals accept both busbar and cable entry from either side, and the tightening torque max of 2.8 Nm is typical for 25 A terminals: a standard screwdriver with a torque-limiting handle avoids over-torque that cracks the housing.

IP rating and enclosure fit

Rated IP20 on the front face — protected against finger contact but not water ingress. IP40 applies to the enclosure sides when the breaker is mounted in a distribution board. This is the standard rating for indoor DIN-rail MCBs in a closed panel; no special sealing needed for a clean, dry electrical room.

MPN
2CDS253103R0254