Skip to main content
Siemens 6ES7132-6BF01-2BA0

Siemens 6ES7132-6BF01-2BA0 Digital Output Module, 4 A, DQ

MPN 6ES7132-6BF01-2BA0
Active

Siemens ET 200SP digital output module, 6ES7132-6BF01-2BA0, DQ type, 4 A at 24 VDC, 15 mm wide, with wire-break and short-circuit diagnostics.

$49.53 – $147.42 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

6ES7132-6BF01-2BA0 specifications
ParameterValue
Depth58 mm
Width15 mm
Height73 mm

Product details

What this DQ module does in an ET 200SP rack

The 6ES7132-6BF01-2BA0 is a digital output module for the Siemens ET 200SP distributed I/O system. It provides four channels of 24 VDC sourcing outputs (DQ type), each rated up to 4 A continuous at 50 °C and the same at 60 °C — no derating between those temperatures, which is unusual for a 15 mm-wide module. The output switches from 0 to 1 in 50 µs at rated load, and from 1 to 0 in 100 µs — fast enough for most valve banks and contactor coils, but not for PWM or isochronous motion axes (MSO and PWM are both listed as No).

Base unit and wiring constraints

This module snaps onto a BU type A0 base unit — that's the standard 15 mm-wide carrier for ET 200SP. The base unit provides the backplane bus connection and the field wiring terminals. For 2-wire and 3-wire sensors, the A0 base unit handles the connections directly; for 4-wire devices you need an additional potential distributor module.

Diagnostics that save a service call

Module-wise wire-break detection is built in — it flags an open load on any channel. The diagnostic threshold range is 48 Ω to 12 kΩ, which covers most solenoid and relay coil circuits. Short-circuit to M and short-circuit to L+ are also detected module-wise, and a group error signal is generated. Diagnostic alarms are supported, and I&M data (I&M0 through I&M3) is available for asset tracking in TIA Portal. Firmware version is V0.0, and no firmware update is possible — the module ships with the factory version.

Cable length and load limits

Unshielded cable runs up to 600 m are allowed; shielded runs up to 1 000 m. The maximum lamp load switching frequency is 10 Hz — fine for indicator lamps, not for strobes or fast pulsing loads. Typical power loss is 1 W. The minimum signal-1 voltage is L+ minus 0.8 V, so at 24 V supply the output holds above 23.2 V at rated current — enough margin for most 24 VDC loads.

MPN
6ES7132-6BF01-2BA0