Siemens 6ES7132-4HB10-0AB0 ET200S 2DO Relay Module, 5A, 15mm

The Siemens 6ES7132-4HB10-0AB0 is a SIMATIC DP ET200S electronic module that fits into a 15 mm slice of the remote I/O station. It gives you two relay outputs with Form C contacts, each rated for 5 A continuous — enough for pilot-duty solenoids or small contactors in a cure-press panel. The coil power comes from the backplane bus (24 V DC via the power module), so you only need to wire the load side L+ and the commons. On the switching side, keep the cycle rate in mind: 2 Hz max on resistive or lamp loads, and 0.5 Hz with inductive loads. That matches a typical press valve that cycles once every few seconds — not a fast-pick-and-place, but fine for a cure recipe's step sequence. Lifecycle status is current. The module ships in a packaging unit of 5 pieces, quoted to order against an RFQ.