What it is and where it lands
The Siemens 6ES7194-2MN10-1AB0 is a preassembled power cable linking an ET 200AL station to its 24 V DC supply, with M8 angled male and female connectors at each end. It's a direct fit for the ET 200AL power distribution segment—no field wiring or splicing needed. The 90-degree outlets save space in tight cabinets or terminal strips.
Key ratings and what they mean for fit
Rated for continuous use across -25 to 80 °C, so it handles the typical factory floor but stays clear of direct heat sources or freezers. The IP65/67 rating means it's sealed against dust ingress and low-pressure water jets—fine for washdown zones or area conveyors with occasional spray. Both connectors are IP65/67 rated at the mating point, so the entire power chain holds the same protection class. The PUR jacket is halogen-free and silicone-free, which matters in clean-room adjacent or automotive painting environments where halogens can cause corrosion or silicone contamination. The material also resists abrasion and many oils, common in cable-track applications. Rated for 2 million bending cycles at 51 mm radius when installed in a cable carrier—this is a cable you can use on moving gantries or robotic dress-out if the travel path matches the bend parameters. The one-time minimum bend radius of 26 mm covers panel-routing during installation. The 4-core 0.50 mm² conductors (white/brown/blue/black) match the ET 200AL power module pinout; the 10 m length covers most cabinet-to-zone distances in a typical conveyor or material-handling layout. If you need shorter, field trimming is possible but the connectors are pre-molded—order a different length variant instead of cutting.