Skip to main content
Siemens 3RW4422-1BC45

Siemens 3RW4422-1BC45 SIRIUS Soft Starter, 50 A, 230 V

MPN 3RW4422-1BC45

Siemens SIRIUS 3RW4422-1BC45 soft starter, 50 A at 40 °C, 230 V AC, 50/60 Hz, 3-phase, integrated bypass contact system, screw-type terminals, IP20.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

3RW4422-1BC45 specifications
ParameterValue
Mountingscrew fixing
Depth270 mm
Width170 mm
Height192 mm

Product details

50 A at 40 °C — the real current rating for a warm panel

The 3RW4422-1BC45: The minimum load is 8 % of the motor FLA — below that the soft starter may not trigger the thyristors cleanly.

Integrated bypass and inside-delta wiring

An integrated bypass contact system means the thyristors are shorted out once the motor reaches full speed — no external bypass contactor needed, and the heat load on the panel drops to near zero during run. The unit also supports inside-delta connection, which lets a smaller-rated soft starter handle a given motor by wiring the thyristors in the delta legs rather than the line. Adjustable current limitation and motor overload protection are built in, so a separate overload relay is optional. The fault display shows the trip cause on the unit itself — no need to pull a laptop for a basic overcurrent or phase-loss read.

Mounting and clearance — fits a standard panel layout

Dimensions are 192 mm high, 170 mm wide, 270 mm deep. Fastening is screw fixing — no DIN-rail clip, so plan for a backplate with tapped holes or PEM studs. Clearance requirements: 100 mm above, 75 mm below, 5 mm at the sides. The mounting position allows vertical surface with ±90° rotation and ±22.5° tilt front/back. Maximum motor cable length is 500 m. Pollution degree 3 per IEC 60947-4-2 — suitable for industrial environments with conductive dust or occasional condensation. Operating temperature range is up to 60 °C during operation; storage range is -25 to +80 °C.

Terminal specs — main and control wiring

Auxiliary and control circuit terminals are screw-type for 2x (20... 14) AWG. The main terminals also accept 10 AWG to 1/0 AWG using both clamping points, or 10 AWG to 2/0 AWG using the front or back clamping point individually. External reset input and intrinsic device protection are standard. The thyristor stack is the switching element — no mechanical contactor wear during start.

MPN
3RW4422-1BC45