The ABB 1SFA896104R7000 sits in the PSR6 soft-starter line and is built for soft start with voltage ramp on three-phase motor loads up to 208... 600 V AC, with a 4xIe for 6s starting capacity that covers typical heavy-inertia starts. Control supply is 100... 240 V AC, so the same chassis can be fed from a panel control transformer worldwide. The 0... 20 second ramp time gives enough span for pump and conveyor profiles without an external potentiometer. Initial voltage during start is adjustable from 40... 70 %, which sets the first kick the motor sees before the ramp walks up. Screw terminals on the main circuit accept rigid conductors from 0.75... 2.5 mm², control circuit 1 x 0.75... 2.5 mm², tightening torque 1 N·m on the control circuit — values that match the rest of the PSR6 family and reuse the same panel-builder layout. IP20 on the main terminals keeps fingers off, which is what you want with the cover off during commissioning. Run signal relay is present; fault, by-pass and overload signal relays are not on this variant.
Sourcing posture and where it drops in the panel
Production status is not asserted from the record for this item. The PSR6 chassis covers 208... 600 V AC and 100... 240 V AC control supply; overload pairing names MS116 4.00... 10.00. Ambient air temperature operation is -25... +60 °C with IP20 on the main terminals. The closer PSR6 sibling is 1SFA896104R1100; R1100 is a different control/supply configuration within the PSR6 frame, so verify the suffix against the panel drawing before swapping. The other two listed peers (1SFA896106R7000 and 1SFA896105R1100) are not the same PSR6 frame.
Compliance trail for the documentation pack
RoHS conformity follows EU Directive 2011/65/EU and Amendment 2015/863 July 22, 2019, WEEE Category 5 (small equipment, no external dimension more than 50 cm), B2B classification. UL/CSA horsepower at 200... 208 V AC three-phase is 1 Hp, UL/CSA control-circuit tightening torque 8.9 in·lb, rated frequency 50/60 Hz.