The AF65-30-11-41: The 68 A rating is the conventional free-air thermal current (Ith) for AC-1 resistive loads. For motor duty (AC-3), expect a lower utilization category — the 68 A figure is the ceiling for resistive heating, not the motor-starting current. The 24-60 VAC coil covers standard control voltages across North American and European panels; verify your control transformer taps before wiring. With a 24-60 VAC coil, this contactor drops into existing 24 VAC or 48 VAC control circuits without a separate transformer. The 1 NO + 1 NC auxiliary block is built in, saving a DIN-rail slot for add-on aux contacts on higher-current frames.
The AF65 frame mounts on DIN rail or panel with four screws. The 68 A rating means 16 mm² or 25 mm² power wiring depending on ambient temperature and bundling; leave at least 10 mm between contactors for heat dissipation. The 24-60 VAC coil draws roughly 8-12 VA sealed — check your control transformer sizing if ganging multiple contactors.