Skip to main content
ABB 1SFA897112R7001

ABB PSE210 Soft Starter 1SFA897112R7001, 208-600V AC, Modbus

MPN 1SFA897112R7001
Active

ABB PSE210 soft starter, 1SFA897112R7001, soft start with torque control, 208...600 V AC, 50/60 Hz, Modbus-RTU, 0...30 s ramp, built-in electronic overload protection.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

1SFA897112R7001 specifications
ParameterValue
Terminal typeMain Circuit: Bars
Voltage208 ... 600 V AC
Frequency50/60 Hz
ProtocolModbus-RTU
Temp operating max60 °C
Temp operating min-25 °C

Product details

What this soft starter does on the line

The ABB PSE210 1SFA897112R7001 is a soft starter with torque control, meaning it ramps voltage to the motor during start rather than slamming it across the line. That ramp time is adjustable from 0 to 30 seconds, and the initial voltage during start can be set between 30 and 70 percent of line voltage. For a pump or conveyor that needs a gentle acceleration curve, this is the parameter that sets the jerk limit. Communication is Modbus-RTU over the control circuit, which runs on 24 V DC. The main circuit terminals are bars — hole diameter 8.5 mm — sized for the 208 to 600 V AC range it operates on. The control supply voltage is separate, 100 to 250 V AC, so the logic stays live even when the motor circuit is off. Built-in electronic overload protection covers locked rotor, current underload, and EOL detection. The current limit function is adjustable from 1.5 to 7 times the motor full-load current, which gives you the headroom to handle high-inertia starts without tripping on the inrush.

Main terminals are rated IP00 per IEC 60529 and IEC 60947-1 — that means no enclosure protection at the terminals themselves, so this unit lives inside a panel or cabinet that provides the overall IP rating. The control circuit connects via rigid 1 x 2.5 mm² wire, torqued to 0.5 N·m. The supply circuit takes the same wire size. Three signal relays are onboard: run, fault, and bypass — all standard for a soft starter that needs to tell the PLC what it's doing.

MPN
1SFA897112R7001