Skip to main content
Schneider Electric LX1LB056

Schneider LX1LB056 TeSys Coil, 56 V AC 50 Hz, Active

MPN LX1LB056
Active

Schneider Electric TeSys LX1 series replacement coil, LX1LB056, 56 V AC 50 Hz control circuit voltage, 75 VA inrush / 8 VA sealed power consumption, 28.09 Ohm resistance.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX1LB056 specifications
ParameterValue
Main product or component typeCoil
Coil voltage56 V AC 50 Hz

Product details

The LX1LB056 is a replacement coil from the Schneider Electric TeSys range, designed for contactors and motor starters that use the LX1 coil platform. It's the part that pulls the contactor in — no coil, no switching. Rated for a 56 V AC 50 Hz control circuit, this coil draws 75 VA inrush at 0.55 power factor and settles to 8 VA sealed at 0.28 power factor. That inrush-to-sealed ratio is typical for AC-operated contactor coils — the high inrush pulls the armature in, then the sealed VA holds it closed with less heat. Coil resistance measures 28.09 Ohm at 20 °C, ±10 %, with an inductance of 0.95 mH. These values matter for troubleshooting — an open coil or a shorted turn shows up as a resistance reading outside that band.

Classified under 18402-WORLD SERVICE PARTS(CONTROL ACCESS), meaning it's stocked as a serviceable spare, not a design-in component for new panels. That's fine for a replacement coil — you're swapping it into an existing TeSys contactor, not specifying it for a greenfield build.

This coil mounts directly onto the TeSys contactor magnet assembly — no adapter, no bracket. The LX1 coil family shares the same mechanical footprint across the D-range contactors, so fit is consistent if you're replacing a failed coil on an LC1D or LC1F frame. Wire the 56 V AC supply to the coil terminals with proper polarity for the AC circuit — AC coils aren't polarity-sensitive, but the suppression network (if fitted) may be. Verify the control transformer is sized for the 75 VA inrush; a marginal transformer can cause the contactor to chatter on pull-in.

MPN
LX1LB056