Skip to main content
Schneider Electric LX4FH022

TeSys LX4FH022 Contactor Coil, 22 V DC, Obsolete

MPN LX4FH022
Active

TeSys range, contactor coil LX4FH022, 22 V DC control voltage, obsolete lifecycle status.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX4FH022 specifications
ParameterValue
Control circuit typeDC wide range
Main product or component typeContactor coil
Coil voltage22 V DC
Temp operating max55 °C
Temp operating min-5 °C
Operating time40...50 ms closing 40...65 ms opening
Operating temperature23...131 °F (-5...55 °C)

Product details

The LX4FH022 is a replacement contactor coil from the TeSys range, designed for FH-series contactors. It operates on a 22 V DC control circuit and is a direct service part for existing TeSys contactor assemblies. The coil has a DC wide-range control circuit type, with an average resistance of 0.72 Ohm inrush and 172 Ohm holding at 20 °C. Control voltage limits are 0.85 to 1.1 Uc for operational range and 0.15 to 0.2 Uc for drop-out, both at 55 °C. The ambient air temperature for operation spans -5 to 55 °C.

The 22 V DC control voltage is the nominal coil supply. The operational voltage limits (0.85 to 1.1 Uc, or roughly 18.7 to 24.2 V DC) tell you the coil will reliably pick up across that range at 55 °C. The drop-out range (0.15 to 0.2 Uc, or about 3.3 to 4.4 V DC) means the contactor will drop out cleanly when the control voltage falls that low, preventing the coil from holding in a partially energized state. The operating time of 40 to 50 ms closing and 40 to 65 ms opening is standard for a power contactor coil. The coil has no built-in suppressor module. This means you need to add an external flyback diode or RC snubber across the coil terminals if your control circuit requires suppression, which is typical for PLC-driven outputs or any DC switching circuit where back-EMF could damage the driver.

MPN
LX4FH022