Skip to main content
ABB 1SFA895003R7000

ABB PST37 1SFA895003R7000 Soft Starter, 37 A, 18.5 kW

MPN 1SFA895003R7000
Obsolete

ABB PST37 series, 1SFA895003R7000 soft starter, 37 A rated operational current in-line, 18.5 kW at 400 V, 100-250 V AC control supply, screw terminals.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

1SFA895003R7000 specifications
ParameterValue
Terminal typeScrew Terminal
VoltageMain Circuit 400 ... 690 V AC
Frequency50/60 Hz
ProtocolFiledBusPlug(Standard)
Temp operating max50 °C
Temp operating min0 °C

Product details

Rated for the motor, not just the nameplate

The ABB PST37 1SFA895003R7000 is a soft starter sized for a 37 A in-line motor load — that's 18.5 kW on a 400 V three-phase supply. In an inside-delta configuration it handles 64 A and 30 kW, which is the wiring you'd use for a larger motor where the starter sits inside the delta loop to reduce the current through the main contacts. The main circuit is rated 400 to 690 V AC, so it covers standard European 400 V and 690 V industrial networks without a separate voltage tap. Built-in electronic overload protection is integrated — no separate overload relay needed in the panel. The current limit function is adjustable from 1.5 to 7 times the set motor current, which lets you tune the start for high-inertia loads or soft-coupled conveyors. Ramp time spans 0 to 120 seconds, with an initial voltage during start adjustable 30 to 70 % and a step-down special ramp from 100 to 30 %. That's enough range for most pump, fan, and compressor starts without external timers.

Control wiring and signals

Control supply voltage is 100 to 250 V AC, with a separate 24 V DC control circuit available for the logic. Screw terminals on the control circuit accept 1 x 2.5 mm² rigid; tighten to 0.5 N·m. The main circuit terminals accept 1 x 10 to 95 mm² rigid. Communication is via a standard FieldBusPlug — the PST37 accepts a plug-in fieldbus adapter, so you can add PROFIBUS, DeviceNet, or Modbus without changing the base unit. Four signal relays are built in: run, fault, by-pass, and overload. Each provides a dry contact for the PLC or status lamp. A red LED indicates a fault condition; a yellow LED signals protection activation. The analog output is 0 to 10 V, typically used to feed a speed or current signal to a remote meter or drive controller.

MPN
1SFA895003R7000