Skip to main content
Schneider Electric ABE7S16E2M0E

Schneider Electric ABE7S16E2M0E Solid State Input Relay Sub-

MPN ABE7S16E2M0E
Active

Schneider Electric Modicon ABE7 series, ABE7S16E2M0E, solid state input relay sub-base, 16 inputs, 230 V AC sensor end, 24 V DC PLC end.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

ABE7S16E2M0E specifications
ParameterValue
Terminal block typeRemovable
Insulation voltage ui2000 V
Frequency<= 25 Hz duty cycle: 50 %
IP ratingIP2X
Response time<= 20 ms from state 1 to 0
Temp storage max80 °C
Temp storage min-40 °C
Temp operating max60 °C
Temp operating min-5 °C
Storage temperature-40...80 °C conforming to IEC 61131-2
Pollution degreePollution degree 2
Channels16
Operating temperature-5...60 °C conforming to IEC 61131-2

Product details

The ABE7S16E2M0E is a solid state input relay sub-base from the Modicon ABE7 range, providing 16 input channels that accept 230/240 V AC from the sensor side and interface with a 24 V DC PLC end. It is designed to isolate field sensors from the controller, with a response time of ≤ 20 ms from state 1 to 0.

The sensor end is rated for 230/240 V AC 50/60 Hz, with a guaranteed state 1 voltage of ≥ 164 V and a state 0 current of ≤ 4.5 mA. This means it reliably detects a '1' signal from standard 230 V AC sensors (e.g., proximity or photoelectric) even with line voltage sag, and a '0' when the sensor leakage is below that threshold. The PLC end operates on 19...30 V DC, with a maximum switching current of 15 mA and a minimum of 1 mA, so it can drive a standard 24 V DC input module without overloading it. Each channel is limited to 0.008 A, and the PLC end has an internal 1 A fast-blow fuse (5 x 20 mm) for protection. An external fast-blow fuse on the sensor end is adjustable per the installation. Compliance with IEC 61131-2 Type 1 means the inputs are designed for 3-wire proximity sensors and similar devices, with defined thresholds for state 0 and state 1. Pollution degree 2 (IEC 60664-1) and installation category II suit it for clean, controlled environments like a panel interior, not for direct outdoor or wet-area mounting.

MPN
ABE7S16E2M0E