The ATV6B0C16T4: Built for cabinet integration, this drive carries an integrated EMC filter meeting IEC 61800-3 category C3 — saves the external filter and cable ferrites for most industrial lineups. The forced-convection cooling keeps it running in enclosure ambients up to the standard derating curve. Safety is SIL3-capable via the STO (Safe Torque Off) function, so you can tie it into a safety-rated stop circuit without a separate contactor. The drive also includes motor thermal protection, phase loss detection, and overvoltage/undervoltage monitoring on the DC bus.
Ratings that drive the decision
At 480 V, the drive's apparent power hits 203 kVA normal duty, so the upstream MCCB and cable need to handle at least 250 A continuous. Switching frequency adjusts from 2.5 to 8 kHz — higher kHz cuts motor noise but derates the output current. For a pump or fan running at 2.5 kHz, you'll get full rated current; at 8 kHz you lose some headroom, so check the derating table in the manual. The drive accepts synchronous and asynchronous motors, so it works with permanent-magnet or induction machines. Prospective line short-circuit rating is 50 kA, which handles most secondary-side substations without a series reactor. Pollution degree 2 and vibration resistance to 0.5 gn at 13–200 Hz mean it's not a delicate instrument — it survives plant-floor rumble.
Lifecycle status is current — you aren't buying into an end-of-life pipeline. The CE marking is listed directly on the nameplate. The drive is designed against IEC 61800-3 (EMC), IEC 61800-5-1 (safety), IEC 61000-3-12 (harmonic limits), IEC 60721-3 (environmental), plus functional safety standards IEC 61508 and IEC 13849-1. That covers most European and harmonized global requirements in one package. Shipment includes a control unit, the power module, mechanical mounting hardware, a power connection set with fuses, and a front cover — no hidden BOM gotchas. The EMC filter is factory-integrated, so the drive arrives ready for a standard industrial panel.
Integration and communication
Cabinet-mount only — not a standalone enclosure, so you'll provide UL type 1 or 12 per UL 61800-5-1 depending on your panel's rating. Forced-convection cooling dictates spacing around the heatsink; the manual gives clearance minimums. Mounting altitude up to 4800 m with derating above 1000 m — fine for most plants except high-altitude mines. Communication is modular: Slot A accepts Profibus DP V1, PROFINET, DeviceNet, Modbus TCP/EtherNet/IP, or CANopen (RJ45, SUB-D 9, or screw terminals). There are also I/O and relay extension option cards for that slot. The base drive has a 2-wire RS-485 Modbus serial port (RTU, 1–247 addresses, 4.8–38.4 kbit/s) and a dual Ethernet port for Modbus TCP (10/100 Mbit, half/full duplex). The Ethernet port supports multiple masters and daisy-chain topologies — good for line-level architecture.