The ENW13269 is a 3-pole switch disconnector from the Schneider Electric EasyPact NW range, rated 1600 A in AC-23A utilization category at 440 V AC — that's the heavy motor-switching duty class, so it handles the high inrush of starting motors and other inductive loads without welding contacts. It's a drawout unit, meaning the switching element slides out of its cradle for safe inspection or replacement without disturbing the main bus connections — a real time-saver in switchgear where uptime matters. Rated insulation voltage is 1000 V AC, with an impulse withstand of 12 kV and a short-time withstand of 50 kA for 1 second, so it's built for distribution panels where fault levels are substantial. It's certified as suitable for isolation per IEC 60947-3, meaning you can safely use it as a visible-break disconnecting means for lockout/tagout procedures.
Mounts on a rail base plate in drawout configuration — the 70 mm connection pitch without spreader matches standard busbar centers, and the rear connection location keeps cabling clean in a fixed-cradle setup. Dimensions are 322 mm high, 288 mm wide, 277 mm deep — factor that depth into your enclosure clearance, especially with the drawout rail travel.