Skip to main content
Schneider Electric ENW24222

Schneider Electric ENW24222 EasyPact NW Switch Disconnector,

MPN ENW24222
Active

Schneider Electric EasyPact NW, switch disconnector, ENW24222, 1000 A AC-23A, 4 poles, fixed mount, IP40.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

ENW24222 key specifications
ParameterValue
Control typePush-button
Main product or component typeSwitch disconnector
Voltage690 V AC 50/60 Hz conforming to IEC 60947-3
Insulation voltage ui1000 V AC 50/60 Hz conforming to IEC 60947-3
CurrentAC-23 A: 1000 A AC 50/60 Hz 690 V
Utilization categoryAC-23 A
IP ratingIP40
Terminal pitch115 mm without spreader
Temp storage max85 °C
Temp storage min-40 °C
Temp operating max70 °C
Temp operating min-5 °C

All specifications

ENW24222 additional specifications
ParameterValue
Storage temperature-40...85 °C without control unit
Pollution degree4 conforming to IEC 60664-1
Depth297 mm
Width537 mm
Height352 mm
ApplicationDistribution
Operating temperature-5...70 °C

Product details

Switch disconnector for high-current distribution

The Schneider Electric ENW24222 is a fixed-mount switch disconnector from the EasyPact NW range, rated for 1000 A in AC-23A duty at 690 V AC. That utilisation category covers switching of motor loads and other highly inductive circuits — the 1000 A figure is the operational current under those conditions, not a resistive-only rating. It carries a 66 kA short-time withstand (Icw) for 1 s and a 143 kA making capacity (Icm), so it can close onto a fault without welding contacts. Suitability for isolation per IEC 60947-3 is confirmed, meaning it provides a visible break and meets the clearance/creepage for a safety disconnect.

Ratings that govern the application

Rated insulation voltage (Ui) is 1000 V AC, and the impulse withstand (Uimp) is 12 kV — this switch can live in a 690 V panel and survive transient overvoltages typical of industrial distribution without tracking. Electrical durability under AC-23A is 6,000 cycles at 440 V and 4,000 cycles at 690 V — the switch is built for occasional load-break duty, not frequent motor starting. For higher cycle counts, a contactor-based solution would be appropriate.

Fixed-mount on a base plate. Dimensions are 537 mm wide × 352 mm high × 297 mm deep — that's a substantial footprint; verify panel door cutout and swing clearance before layout. Rear connection with horizontal or vertical orientation. Neutral position is left. The 4-pole configuration (3 phases + switched neutral) is common for distribution boards where the neutral must be isolated.

MPN
ENW24222