Hybrid cable for LXM62 servo – power and feedback in one jacket
The FCE307050A200 is a hybrid cable purpose-built for the Schneider Electric PacDrive 3 servo drive family, specifically the LXM62-SC005_16mm stainless motor. It combines motor power conductors and encoder feedback lines in a single shielded jacket, so you run one cable from the drive cabinet to the motor instead of two separate runs. Length is 5 m (16.4 ft) – a common reach for a small automation cell or conveyor section. The cable is shielded, which keeps conducted EMI off the encoder lines and helps pass CE emissions testing on the machine.
Connector arrangement – 3 plug-in + 1 RJ45
The motor end terminates in three plug-in connectors for the power phases and brake/holding circuit, plus a separate RJ45 connector for the encoder feedback. This matches the LXM62 motor connector layout: the RJ45 carries the Hiperface DSL or similar single-cable feedback protocol, while the three power pins handle the motor winding and brake. Because the cable is pre-terminated at both ends, there is no field wiring or crimping – just plug the connectors into the motor and the drive. The plastic jacket is rated for the flex and oil resistance typical of machine-tool and packaging lines.
Active production – no spare-part anxiety
The category code US1PC5218353 is the Schneider internal classification for connection accessories under PacDrive 3. It confirms the cable is a genuine accessory, not a third-party equivalent.