What this cable connects and where it runs
The FCE308035A200: This is a PacDrive 3 hybrid cable — it bundles motor power and encoder feedback into one shielded assembly, terminating in three plug-in connectors for the drive end and one RJ45 for the encoder link back to the controller. The 3.5 m (11.5 ft) length suits cabinet-to-machine runs where the servo drive sits in a panel and the LXM52 motor is mounted on the axis — long enough to reach across a typical machine frame but short enough to avoid excess cable loop inductance on the motor phases.
Obsolete — sourcing path for this cable
Schneider Electric lists the FCE308035A200 as obsolete — no longer in active factory production. For a line already wired with this hybrid cable, the replacement path is through independent surplus or broker channels. Quantities are confirmed at RFQ; no pin-compatible successor from Schneider is recorded on this listing.
Shielding and connector count — what fits where
The shielded motor cable construction keeps drive PWM noise off the encoder pair — critical on a PacDrive 3 system where the feedback loop runs at high update rates and a noisy cable can cause position errors or drive faults. Three plug-in connectors on the drive side mate with the corresponding ports on the LXM52 servo drive; the single RJ45 carries the encoder signal back to the motion controller, so the cable replaces two separate motor and feedback cables with one assembly.