Obsolete — sourcing through independent channels
Schneider Electric lists the FCE308090A200 as obsolete. No stock-holding claim is made.
Hybrid cable for PacDrive 3 stainless servo
This is a hybrid cable — it combines motor power and feedback/signal conductors in one jacket, reducing the number of separate runs between the drive and the motor. The shielded construction protects the signal pair from motor-drive noise, which matters for encoder feedback integrity on a servo axis. Cable length is 29.5 ft (9 m), and the connector set is 3 x plug-in plus 1 x RJ45. The RJ45 carries the communication link (typically SERCOS or CANopen on PacDrive 3), while the plug-in connectors handle the power phases and brake. The cable is specifically designed for the Stainless LXM52-SC005_16mm servo motor — the connector pinout and conductor gauge match that motor's power and feedback requirements. Using a different cable risks a pin mismatch or insufficient current capacity.
What to check before ordering
Since the part is obsolete, confirm the exact connector keying and pinout against your existing drive and motor terminals. The 3 plug-in connectors are likely M23 or M40 power connectors, but the specific thread and contact arrangement should be verified against the mating halves on the drive and motor. The material is listed as plastic — the cable jacket and connector housings are polymer, not metal. This is fine for most industrial environments, but if the cable runs through a high-temperature or abrasive area, a metal-braid armoured alternative may be needed.