Cable run for a PacDrive 3 servo axis
The FCE312050A200: This is the power cable that connects a detached servo drive to a 40 mm motor in the PacDrive 3 range — 5 m long, shielded, with an M17 connector on the drive end and an S915 on the motor end. The shielding is the key detail here: it's a shielded motor cable, so it keeps the PWM switching noise from the drive off the rest of the machine wiring. On a multi-axis line, that matters for encoder feedback integrity and for keeping the EMC test pass.
Connector fit — M17 to S915
One end is an M17 connector, the other is an S915 — these are the standard interfaces on Schneider's PacDrive 3 servo drives and 40 mm motors. No adapter needed if both ends match; just confirm the drive and motor connector types on your BOM before ordering. The cable is 5 m long (16.4 ft), which is a common run length for a servo axis where the drive cabinet sits near the machine frame. If you need a different length, the FCE3 family has other variants — but this one is the 5 m version.