The GBX0600320582D is a 60 mm-diameter planetary gearbox with a 32:1 reduction ratio, straight teeth, and 25 arc.min maximum torsional backlash. It delivers 44 N.m continuous output torque and peaks at 70 N.m maximum — the continuous figure governs steady-state sizing; the maximum covers acceleration transients and occasional overloads within the duty cycle. Rated service life is 30000 hours at 100 rpm input and 30 °C ambient. The axial and radial force limits at that speed are 450 N and 340 N respectively, applied at mid-distance on the output shaft. These bearing load ratings drop if the application runs above 100 rpm or at higher ambient temperatures. Efficiency is listed at 94 %, which is typical for a single-stage planetary with straight teeth. The noise level at no-load is 58 dB at 1 m — straight-tooth gears are inherently noisier than helical, so this figure matters for noise-sensitive installations near operators or in quiet production areas.
Obsolete — sourcing reality for the GBX0600320582D
Schneider Electric lists the GBX0600320582D as obsolete. The part is available through independent surplus and broker channels — quantities are lot-specific and confirmed at RFQ. The housing is black anodized aluminium, the shaft is C 45 steel, and the gearbox is lubricated for life — no maintenance interval for grease changes. Shaft output sealing is IP54, so the unit is splash-resistant but not rated for washdown or submerged service. Mounting position is any orientation. The torsional rigidity of 2.5 N.m/arcmin and moment of inertia of 0.064 g.cm² are the parameters a servo system designer needs for reflected inertia matching and windup stiffness calculations.