The GBX0600601002F is a 60 mm-diameter planetary gearbox with a 60:1 reduction ratio, delivering 44 N.m continuous output torque at 100 rpm and 30 °C ambient. The 94 % efficiency figure means 6 % of the input power is lost as heat in the gear train — budget that thermal load into the enclosure if the duty cycle is sustained. Maximum output torque reaches 70 N.m at the same speed and temperature — this is the peak overload capacity for acceleration or momentary stall, not the continuous rating. The 30000-hour service life at 100 rpm and 30 °C sets the L10 bearing life under rated load; running at higher speed or temperature derates that interval.
Backlash, noise, and ingress — the integration constraints
Maximum torsional backlash is 22 arc.min — this is the lost motion at the output shaft when reversing direction. For positioning axes that require repeatability under 10 arc.min, this gearbox introduces too much play; a helical or low-backlash planetary would be needed. The straight-tooth geometry is the source of both the backlash figure and the 58 dB noise level at 1 m no-load — straight teeth are noisier than helical but lower-cost to manufacture. Shaft output is rated IP54, meaning the output seal resists dust ingress and splashing water — suitable for washdown-adjacent areas but not for pressurized spray or immersion. The black anodized aluminium housing resists corrosion in humid or mildly acidic environments; the C45 steel shaft handles standard keyed or clamping couplings. Maximum radial force at the output shaft is 340 N at 100 rpm for the 30000-hour life target, rising to 500 N if the application accepts a 10000-hour service life. Axial force limits are 450 N and 600 N respectively under the same duty splits. Overhung loads from belt drives or pinions must stay within these envelopes to avoid premature bearing failure.
Obsolete — sourcing through independent channels
Schneider Electric lists the GBX0600601002F as obsolete. The part is sourced through independent surplus and broker channels — quantities are lot-specific, and availability is confirmed at RFQ time, not from a live stock count. The gearbox is lubricated for life, so no field oil-change schedule applies — the sealed grease charge is good for the rated service life. The ambient operating range is -25 to 90 °C, which covers most indoor industrial environments but not freezer or high-heat zones without derating the life target.