The LC1K06013FE7 is a TeSys K three-pole contactor rated for motor control in AC-3 and AC-3e duty at 6 A up to 440 V, with a 115 V AC coil. It carries one normally closed instantaneous auxiliary contact. Coil inrush is 30 VA at 20 °C, holding at 4.5 VA; heat dissipation runs 1.3 W. The coil has no built-in suppressor module, so if you are driving it from a PLC output or solid-state relay, plan an external flyback diode or RC snubber across the coil to protect the switching device.
Electrical durability is 1.3 million cycles at 6 A AC-3, and 50,000 cycles at 36 A AC-4 — the AC-4 figure matters if you are jogging or inching the motor under load, which wears the contacts faster. Mechanical durability is 10 million cycles, so the mechanical life is rarely the constraint in a control panel. Minimum switching capability is 5 mA at 17 V for signalling circuits — useful if the auxiliary contact feeds a low-power PLC input or indicator, but verify the load is above that threshold to avoid contact film issues. The contactor is rated for safety-related applications with a B10d of 1,369,863 cycles at nominal load per EN/ISO 13849-1. That is a statistical reliability figure for the dangerous failure rate — useful if you are calculating the PFHd for a safety circuit. Operating time is 10 to 20 ms for both coil energisation and de-energisation, with a non-overlap distance of 0.5 mm between NO and NC poles — fast enough for most sequencing but not a high-speed transfer switch. Maximum operating rate is 3600 cycles per hour, or one operation per second — fine for frequent cycling in packaging or material handling.
Certified to EN/IEC 60947-4-1, UL 60947-4-1, CSA C22.2 No 60947-4-1, GB/T 14048.4, and JIS C8201-4-1 — covers most global markets without a separate variant. Also listed to IEC 60335-1 and UL 60335-2-40 for appliance applications. Shock and vibration ratings are given per IEC 60068-2-27 and -2-6 — the contactor stays closed under 10 Gn on X and 15 Gn on Y/Z axes, which is robust for mobile or rail equipment.