It's built for standard industrial environments and carries an IP55 rating, meaning it handles dust and water jets from any direction, so it's fine for washdown areas or outdoor installs under a cover. The thermal protection adjustment range is 0.16 to 0.25 A, which matches it to very small motors — think fractional-horsepower pumps, fans, or conveyors. At 400/415 V AC 50/60 Hz it handles a 0.06 kW motor. Control voltage is 110 V AC 50/60 Hz. The front panel has a white push-button for start, black for stop, and a red mushroom-head emergency stop. That's the standard three-button layout for local motor control — no extra pilot devices needed if this is the only control point.
The enclosure dimensions are 177 mm deep by 175 mm wide by 165 mm high. Cable entries: four top and four bottom, each accepting two Pg 13 and two Pg 16 glands. That gives you plenty of room for incoming supply and outgoing motor cables plus control wiring. The polycarbonate material means it's lightweight and corrosion-resistant — no rust worries in a damp environment.