Skip to main content
Schneider Electric LX1FX175

TeSys LX1FX175 contactor coil, 175 V AC 50/60 Hz

MPN LX1FX175
Obsolete

Schneider Electric TeSys LX1FX175, contactor coil, 175 V AC 50/60 Hz, 5 Mcycles mechanical durability, active production.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX1FX175 specifications
ParameterValue
Control circuit typeAC 50/60 Hz
Main product or component typeContactor coil
Coil voltage175 V AC 50/60 Hz
Mechanical life cycles5 Mcycles

Product details

The LX1FX175 is a replacement contactor coil from the TeSys range, built for LX1F contactors that run on a 175 V AC control circuit at 50/60 Hz. That voltage is the coil's nominal pick-up — it's what the contactor needs to pull in and hold. If your panel's control transformer or supply bus is 175 V AC, this coil matches without a step-down. It's rated for 5 million mechanical cycles and can operate at up to 600 cycles per hour at 55 °C. For a contactor coil, that's a solid duty cycle — it'll handle frequent jogging or repetitive start/stop sequences on a conveyor or pump station without wearing out the armature prematurely.

The 175 V AC coil is the main spec to get right. Wire it into a 120 V or 240 V control circuit and it won't pull in reliably — or it'll burn out. This is a common gotcha when swapping coils on older LX1F contactors: verify your control voltage at the coil terminals, not the transformer tap. The 5 Mcycles mechanical durability tells you the coil's plunger and yoke will last through roughly 5 million operations before the mechanical parts fatigue. In a typical panel running 10 cycles per hour, that's over 50 years of service. The electrical life (contact wear) will be shorter depending on your load, but the coil itself won't be the weak link. The 600 cycles/hour max at 55 °C means the coil can handle rapid re-energization without overheating. If your application needs faster cycling — say a high-speed pick-and-place — you'd need to derate or look at a DC coil variant.

MPN
LX1FX175