The LX1LB080 is a replacement coil from Schneider's TeSys range, designed for 80 V AC 50 Hz control circuits. It's the spare part you order when the original coil on a TeSys contactor or starter fails, or when you're building a panel with a non-standard control voltage.
Coil resistance is 57.38 Ohm at 20 °C ±10 % — that's the cold measurement. It determines the inrush current and the holding current the control transformer or PSU must deliver. The inrush power is 75 VA at 0.55 power factor (50 Hz); once sealed, it drops to 8 VA at 0.28 PF. That 9:1 ratio means the transformer must be sized for the inrush peak, not the sealed draw, or the voltage will sag and the contactor may chatter. Inductance is 0.95 mH — relevant if you're calculating the L/R time constant for suppression circuits or verifying compatibility with a PLC solid-state output driving the coil.
Lifecycle status is active per Schneider, so this is a current-production part — no last-time-buy pressure. It's specified into the BOM line as a service spare (category 18402).