Skip to main content
Schneider Electric LX4D6LD

Schneider TeSys LX4D6LD Contactor Coil, 200 V DC, 51.9 Ohm

MPN LX4D6LD
Obsolete

Schneider Electric TeSys LX4D6LD, contactor coil, 200 V DC, 51.9 Ohm at 68 °F (20 °C), without built-in suppressor module.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX4D6LD specifications
ParameterValue
Main product or component typeContactor coil
Coil voltage200 V DC
Temp operating max60 °C
Temp operating min-5 °C
Mechanical life cycles10 Mcycles
Operating temperature23...140 °F (-5...60 °C)

Product details

The LX4D6LD is a replacement coil for the LX1D6 contactor in the TeSys range. It operates on a 200 V DC control circuit and draws its holding current through a 51.9 Ohm winding at 68 °F (20 °C). This is a bare coil — no built-in suppressor module. On a DC coil, the inductive kickback is higher than an AC equivalent, so you need an external free-wheeling diode or varistor across the coil terminals. Wire it with the cathode to the positive rail; reversed polarity shorts the diode and kills the drive transistor on the PLC output card.

Rated for 200 V DC control voltage — this is the nominal pick-up and hold voltage. On a DC coil, the inrush current is limited only by the DC resistance, so the 51.9 Ohm winding draws about 3.85 A during pick-up before the armature seats and the inductance rises to 4.18 H. That rate is the mechanical limit — the contactor's electrical life at rated load will be lower. For high-duty applications like rapid cycling conveyors, check the contactor's electrical endurance curve against your load current. Ambient temperature range of -5 to 60 °C. Within a sealed panel near a drive or transformer, ambient can exceed 50 °C — this coil is rated to handle it. Below -5 °C, the coil's pick-up voltage may shift; the DC resistance drops with cold, increasing inrush current, but the magnetic circuit's reluctance also rises. Not recommended for freezer applications without pre-heating.

MPN
LX4D6LD