Skip to main content
Schneider Electric LX9FL934

Schneider Electric LX9FL934 TeSys F contactor coil, 300-334

MPN LX9FL934
Active

Schneider Electric TeSys F, specific contactor coil, LX9FL934, 300-334 V DC low consumption.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX9FL934 specifications
ParameterValue
Control circuit typeAC 40...400 Hz low consumption DC low consumption
Main product or component typeSpecific contactor coil
Coil voltage300...334 V DC
Temp operating max55 °C
Temp operating min-5 °C
Mechanical life cycles5 Mcycles
Operating time60 ms opening 20 ms closing
Operating temperature23...131 °F (-5...55 °C)

Product details

The LX9FL934 is a specific replacement coil for the TeSys F range of contactors, designed for a control circuit voltage of 300 to 334 V DC. It's a low-consumption coil without a built-in suppressor module, so you'll need to add a free-wheeling diode or RC snubber externally if the circuit requires it. The coil pulls 733 W inrush at 20 °C and holds at 48 W — the inrush is a brief spike, but your DC supply needs to handle that surge without dropping below the 85% operational limit.

The control voltage limits are tight: operational from 0.85 to 1.1 Uc (255 to 367 V DC at 55 °C), drop-out between 0.3 and 0.5 Uc (90 to 167 V DC). If your DC bus sags below 255 V during a brownout, the contactor drops — plan your control transformer or UPS accordingly. Opening time is 60 ms, closing 20 ms — fast enough for most motor and resistive load switching, but if you need arc-sync or zero-cross switching, this coil's mechanical speed is the limiting factor, not the electronics. Rated for 5 million mechanical cycles at a maximum operating rate of 1800 cycles per hour at 70 °C. That's about one operation every two seconds — fine for conveyor cycling or pump start/stop, but not for high-speed pick-and-place or welding gun duty. Heat dissipation runs 22.8 to 27.8 W at full hold — that's non-trivial in a sealed panel. If you're grouping multiple TeSys F contactors, account for this in your thermal budget to avoid derating the coil's ambient temperature range of -5 to 55 °C.

MPN
LX9FL934