Motor specs that decide the drive match
The MH30702P01F2200: This is a three-phase servo motor from the MH3 family, sized for 1380 W continuous power and matched to Schneider's LXM52 or LXM62 drive series. The nominal speed is drive-voltage dependent — 1250 rpm at 115 V single-phase input, up to 7000 rpm at 480 V three-phase — so the drive selection sets the speed-torque envelope you actually get on the shaft. The holding brake is integrated, delivering 26.6 lbf.in (3 N.m) holding torque with a 7 W pull-in power — low enough that the drive's brake control circuit handles it without an external relay. For vertical-axis loads or Z-axis stages, that brake is what keeps the load from drifting when the drive is disabled. Encoder feedback is a single-turn SinCos Hiperface type — absolute position within one revolution, no homing cycle needed on power-up for rotary applications. The 10-pole motor design gives a smooth torque ripple profile at low speeds, which matters for contouring or indexing moves.
Torque, inertia, and thermal limits for the motion profile
Continuous stall torque is 21.95 lbf.in (2.48 N.m) across the 115–480 V three-phase range, with a continuous stall current of 2.94 A. Peak stall torque hits 65.5 lbf.in (7.4 N.m) — about 3× the continuous rating — so the motor can handle acceleration and deceleration transients without tripping the drive's current limit, as long as the duty cycle stays within the thermal time constant. Maximum mechanical speed is 8000 rpm, but the radial force the bearings can sustain drops with speed — 710 N at 1000 rpm down to 390 N at 6000 rpm. If your application has a heavy belt or gear load on the shaft, derate the speed or check the radial force curve against the load.
Mounting, sealing, and wiring for the cabinet
Mounts on an international standard flange with a 70 mm flange size and 60 mm centring collar diameter. The centring collar depth is 2.5 mm — enough to locate the motor squarely on the machine frame without shimming. Four mounting holes at 5.5 mm diameter on the flange face. IP65 standard protection means the motor body is sealed against dust ingress and low-pressure water jets — suitable for washdown areas in food processing or packaging lines. Cooling is natural convection, so no external fan or coolant lines needed; the continuous power rating assumes free air circulation around the motor housing. Electrical connection uses rotatable right-angled connectors — you can orient the cable exit to clear cabinet walls or adjacent motors. The shaft is smooth (no keyway), 11 mm diameter, 23 mm shaft length — typical for direct coupling to a load via a flexible jaw coupling or bellows coupling.