Motor ratings that decide the drive match
The MH31002P12A2200 delivers 5.67 Nm nominal torque when paired with an LXM52 or LXM62 drive at 115 V three-phase input; torque drops to 4.2 Nm at 480 V three-phase, so the drive voltage directly sets the available shaft torque. Continuous power is 2270 W, and the motor spins to 4000 rpm nominal — that speed range suits direct-drive or low-ratio applications on conveyors, spindles, or indexing tables where you want to skip a gearbox. Peak stall torque hits 18 Nm (159.3 lbf.in) across the 115–480 V three-phase range, giving headroom for acceleration transients without oversizing the frame.
Encoder feedback and environmental sealing
The Multiturn SinCos Hiperface encoder provides absolute position feedback over multiple shaft revolutions — no homing cycle needed after a power cycle, which saves time on machines with long travel axes. IP65 rating means the motor body resists dust ingress and low-pressure water jets; it's suited for washdown zones in food or packaging lines, though the connector must be properly mated to maintain the seal. Cooling is natural convection — no fan, so the motor relies on the mounting flange and ambient airflow to shed heat; derate continuous torque if installed in a confined cabinet or near other heat sources.
Shaft, mounting, and mechanical fit
The shaft carries a parallel key (6 mm key width, 19 mm diameter, 40 mm shaft length) and the motor mounts on an international standard flange with a 100 mm flange size and 95 mm centring collar. Maximum radial force at the shaft nose is 990 N at 1000 rpm, dropping to 620 N at 4000 rpm — keep belt tension or overhung load within that curve to avoid bearing fatigue. Electrical connection uses rotatable right-angled connectors, which helps route cables in tight panels without bending the cable beyond its minimum radius.