3730 W continuous power — sizing the motor to the load
The MH31402P17F2200 delivers 3730 W continuous power, which sets the thermal limit for sustained duty cycles — match this to the RMS power demand of the application, not the peak transient. Nominal torque is 16.34 N.m, and the continuous stall torque holds at 18.5 N.m across the full 115...480 V three-phase input range, so the motor delivers rated torque even at standstill for positioning applications. Peak stall torque reaches 55.5 N.m for acceleration transients — the overload margin is roughly 3× continuous torque, enough for rapid indexing without oversizing the frame.
Brake and encoder — holding and feedback for vertical axes
The integrated holding brake delivers 18 N.m holding torque — sized for vertical-axis loads where the brake must hold the full payload at power-off without back-driving the gearbox. Brake pull-in power is 18 W, so the DC bus or external 24 V supply must budget this current; the brake releases when power is applied and engages on power loss. The multiturn SinCos Hiperface encoder provides absolute position feedback over 4096 revolutions without battery backup — eliminates home-seeking on power-up for multi-turn rotary or linear axes.
IP65 and mechanical interface — washdown-ready with standard flange
The 140 mm flange (5.5 in) with 130 mm centring collar and 11 mm mounting holes matches the international standard flange pattern — direct bolt-on to common gearbox and machine frames. Rotatable right-angled connectors allow the cable exit to be oriented in 4 directions after installation — useful when the motor is mounted in a tight cabinet corner or against a machine wall.
No stock-holding claim — quoted per order. The motor mates with LXM52 and LXM62 drive families — nominal speed and torque vary with drive input voltage (115 V, 230 V, 400 V, 480 V), so confirm the drive model and supply voltage when specifying.