The SH31003M12F2200 is a 1500 W continuous-power servo motor with an integrated holding brake — the brake holds 79.7 lbf.in (9 N.m) when the drive is off, so vertical-axis loads stay put without a separate mechanical lock. Nominal torque and speed both shift with the supply voltage: at 400 V three-phase you get 62.0 lbf.in (7 N.m) at 2000 rpm; at 480 V three-phase it's 59.83 lbf.in (6.76 N.m) at 2400 rpm. The motor delivers peak stall torque of 250.5 lbf.in (28.3 N.m) across the 115...480 V three-phase range — that's the torque available for acceleration or overcoming a jam. The absolute multiturn SinCos Hiperface encoder means the drive knows the shaft position on power-up — no homing cycle needed after a power loss. That saves time on multi-axis machines where every axis would otherwise have to find its reference.
Mounting and integration — flange, shaft, and connector
The motor uses an international standard flange with a 3.9 in (100 mm) bolt circle and 0.4 in (9.0 mm) mounting holes — fits the common 100 mm frame pattern. The shaft is 0.7 in (19 mm) diameter with a parallel key, 1.6 in (40 mm) long. The electrical connection is a rotatable right-angled connector — you can orient the cable exit in four directions to fit tight cable-tray routing without adding a separate right-angle adapter. IP65 on the motor body and shaft bushing, IP67 on the housing — that's washdown-rated for food-and-bev or wet machining lines. Natural convection cooling means no fan to clog or fail, but the thermal budget depends on free air movement around the finned housing.
Sourced through independent distribution channels against an RFQ.