Active production — 2400 W continuous, 100 mm flange
The SH31003P01A1200: Rated for 2400 W continuous power, this motor delivers nominal torque ranging from 5.1 N.m at 480 V three-phase up to 7.5 N.m at 115 V single-phase, with nominal speeds spanning 1000 rpm at 115 V to 4800 rpm at 480 V. The 100 mm international standard flange (3.9 in) and 19 mm smooth shaft with 40 mm shaft length define the mechanical interface — it bolts directly to standard NEMA or IEC mounting patterns.
Torque delivery across the speed range
Continuous stall torque sits at 8 N.m (70.8 lbf.in) across the 115...480 V three-phase input range, with a continuous stall current of 6.6 A. Peak stall torque reaches 28.3 N.m (250.5 lbf.in) — that's a 3.5x overload capability for acceleration and deceleration phases, limited to 3 seconds peak at 28.3 A. The torque constant is 1.22 N.m/A at 120 °C copper temperature, and the back EMF constant is 77 V/krpm at 20 °C. These two parameters let the drive calculate the motor's electrical behavior — the stator inductance of 4.7 mH and resistance of 1.43 Ohm define the electrical time constant and winding losses for servo loop tuning.
Encoder, cooling, and environmental sealing
The absolute single-turn SinCos Hiperface encoder provides position feedback without needing a homing sequence on power-up — the drive reads the absolute position within one revolution. This saves a home-switch input and a homing routine on every power cycle, which matters on multi-axis machines where lost position on a power bump means re-referencing the whole line. Cooling is natural convection — no fan, no forced air, no coolant lines. That means the 2400 W rating assumes free air circulation around the motor body; mounting it in a tight enclosure or against a heat sink changes the thermal budget. The IP65 rating on the motor body and shaft bushing, plus IP67 on the housing per IEC 60034-5, means it handles washdown environments — food processing, packaging lines, outdoor conveyors — without condensation ingress. Electrical connection is via a straight connector — no right-angle plug to fight with in tight cable trays. The 4-pole rotor design keeps the motor length compact at 240.5 mm (9.5 in) for the power class.
Sourcing — active, quoted to order
The sizing reference is SH31003P, which ties to Schneider's motion sizing tools — if you're replacing a motor in an existing machine, the same sizing reference means the drive tuning parameters should carry over.