Motor specs that decide the fit
The SH31004P0BF3000: This SH3 series servo motor delivers 2.5 kW continuous power and hits 3000 rpm on 400 V three-phase supply — the nominal torque at that point is 7.9 N·m, but the holding brake locks 12 N·m, so it holds a vertical load without back-driving the gearbox. The absolute multiturn Hiperface DSL encoder means no homing sequence on power-up — the position is known from the moment the drive enables, which saves a cycle on every restart. IP65 on the motor body (with IP54 at the shaft bushing unless a seal ring is fitted) means it handles washdown in food or beverage lines, but the shaft seal needs attention if water jets hit the output end directly.
Brake and torque — what the numbers mean
The holding brake pulls 18 W to release — factor that into the 24 VDC supply sizing if the brake is held open for long periods; the coil temperature rise is accounted for in the 130 °C copper hot rating. Peak stall torque hits 40.5 N·m across the 115–480 V three-phase range — that's the short-duration torque for acceleration or emergency stop, not continuous duty. Continuous stall torque is 10 N·m at 6.2 A.
Mounting and connection details
International standard flange, 100 mm square, with a 95 mm centring collar and 9 mm mounting holes — bolts directly to the standard IEC metric pattern without adapter plates. Smooth shaft, 24 mm diameter, 50 mm long — no keyway, so the coupling or pulley must clamp onto the shaft with a friction lock; the smooth end gives a clean interface for collet-style couplings. Straight quicklock connector for power and feedback — no right-angle adapter needed in tight cabinets, but leave clearance for the connector body and cable bend radius.