The Schneider VW3A83CDG050 is a 5-meter GG45 Digi-Link cable used to connect the power module to the control unit in an Altivar Process Modular single-drive architecture.
The GG45 connector is purpose-made for the Altivar Process Modular backplane — it's not a standard RJ45 patch cable. The 5-meter length gives you enough reach to separate the power stack from the control head in a typical cabinet layout without excess coil. This cable carries the Digi-Link communication between modules, so using the correct GG45 type avoids signal integrity issues that a generic Ethernet cable could introduce.
If you're freezing a BOM or stocking spares for a line that uses these drives, this cable is a straight drop-in; no revision change or alternate part number to track right now.
In a single-drive architecture, the power module and control unit are separate physical units. This cable bridges the two — typically routed through a wire duct or cable tray inside the enclosure. The 5-meter length is generous enough for a standard 800 mm wide cabinet with the modules stacked vertically.