The VW3L3D02R30 is a pre-wired connector cable, 3 m (9.8 ft) long, terminated with a 10-pin crimp connector on one end and open on the other. It carries the RS485 communication interface and is designed specifically for Schneider Electric Lexium stepper motor drives and Lexium integrated drives.
The 3 m (9.8 ft) cable length suits panel-to-drive runs where the drive sits within a few meters of the controller or I/O node. The RS485 interface means this cable carries the differential serial signal for drive parameterization and control — not power, not encoder feedback. The 10-pin crimp connector mates to the drive's communication port; the open end terminates in a terminal block or D-sub connector at the controller side.