The VW3L3D03R30 is a pre-wired connector cable from Schneider Electric's Lexium accessory range, purpose-built for connecting a stepper motor drive to its motor and encoder. It runs 3 m (9.8 ft) and terminates at the drive end in an industrial M23, 12-pin connector that carries supply voltage, multifunction signals, and communication. The other end is open — bare wires ready for crimp termination into a mating 19-pin connector. This is the cable you spec when you need a factory-assembled, shielded link between the drive and the motor, not a field-built pigtail.
Connector breakdown
The M23 end is a single 12-pin connector that bundles the supply voltage, multifunction interface, and communication lines into one rugged circular shell — typical for Lexium stepper drives where the motor power, encoder feedback, and brake control share a common cable. The open end gives you 19 wires to crimp into a mating connector (not included), so the cable can be terminated to match whatever motor or junction box is on the machine. That 19-pin count matches the signal set of a typical stepper motor with encoder and holding brake.