What this switch does on the line
The Schneider Electric XCMD2110L3 is a miniature, snap-action limit switch in a metal body with a metal end-plunger actuator and a 1NO-1NC contact block, wired out through a 3 m pre-wired cable so it drops straight into a conduit-free panel entry or a cord-glanded machine housing. Snap-action operation gives a defined make/break at the trip point regardless of plunger speed — important on conveyors, door interlocks, and packaging machinery where a slow cam can otherwise stall a slow-make contact and drop the output. Position-detection on moving parts — end-of-stroke confirmation on a cylinder, guard-door status on a safety circuit, or part-present signal on an indexing table — is the typical application for this class of miniature switch.
Ratings and what they constrain
The contact block is rated 240 VAC at 1.5 A and 250 VDC at 0.1 A — that is a low-current control-circuit rating, not a motor-starter rating; the XCMD2110L3 is sized to drive a relay coil, PLC input, or indicator, not a contactor coil directly. EN/IEC 60947-5-1 governs low-voltage switchgear control devices and EN/IEC 60204-1 covers electrical equipment of machines — the standards listed for this part define both the contact performance envelope and the machine-safety context it is approved to live in. Approvals include UL 508, CSA C22.2, CE, and CCC — the UL/CSA pair covers North American industrial control panels, CE covers the EEA, and CCC covers China-market machinery, so the same SKU travels across a multi-region build without re-spec. Operating temperature runs from -13 to 158 °F (-25 to 70 °C), which covers unheated outdoor cabinets in winter and the inside of a control panel next to a drive in summer without derating.
Enclosure and panel fit
The housing is rated NEMA 4X/6P/12/13 and IP66/IP67, so the switch body withstands water-jet washdown, dust ingress, and temporary immersion — appropriate for food-and-beverage lines, outdoor machinery, and any cell that gets hosed down at end of shift. Overall dimensions of 1.18 in W × 0.63 in D × 1.97 in H keep the footprint compact; the pre-wired 3 m cable lets the installer route through an existing cable gland without a connector at the switch body. Two-pole construction with the 1NO-1NC contact form is the standard hookup for a guard-door interlock (NC channel in the safety loop, NO channel for the PLC position indicator) without needing a second switch.
Lifecycle and spares posture
The 1NO-1NC miniature format with a metal end plunger is a long-standing XCMD configuration; swapping the actuator type (roller, lever, whisker) or the cable length is the typical change between siblings without disturbing the footprint or wiring.