The Square D XUZA41 is a Telemecanique XUZ-series 90° mounting bracket, built in metal and intended to hold an XUJ-series photoelectric sensor on the panel face. It is sold under the Square D / Telemecanique brand and catalogued as a sensor accessory in the sensor-mounting-bracket sub-category, with a 90° body angle and a three-hole / three-slot sensor face that mates to the XUJ footprint.
Fit and mounting geometry
The bracket is specified for XUJ-series photoelectric sensors, so on a line-down swap the same housing footprint is what the replacement carries — no adapter plate needed for an XUJ head. The sensor side of the bracket is a three-hole, three-slot pattern; the panel side takes a hole-and-slot mounting configuration, which gives the installer a single slotted hole for slide-and-tension alignment before the remaining fasteners are torqued.
Body and material
The 90° body is metal rather than plastic, which is the choice that matters on a vibrating conveyor or near a motor — plastic L-brackets in that service crack at the bend, and the metal XUZA41 is what the XUJ head was designed to ride on.
Lifecycle stage on this listing reads current, so the part is specified into the BOM as a standard sensor accessory rather than a last-time-buy line. Sourcing is to order against an RFQ — quote the MPN and quantity, and the channel is the regular Square D / Telemecanique supply path through this desk.