Skip to main content
Schneider Electric LX1FF026

TeSys LX1FF026 Contactor Coil, 26 V AC 50 Hz, Active

MPN LX1FF026
Obsolete

Schneider Electric TeSys F LX1FF026 contactor coil, 26 V AC 50 Hz, active production.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

LX1FF026 specifications
ParameterValue
Control circuit typeAC 50 Hz
Main product or component typeContactor coil
Coil voltage26 V AC 50 Hz
Temp operating max55 °C
Temp operating min-5 °C
Mechanical life cycles10 Mcycles
Operating time23...35 ms closing 5...15 ms opening
Operating temperature23...131 °F (-5...55 °C)

Product details

The LX1FF026 is a replacement coil for TeSys F contactors, wound for 26 V AC at 50 Hz. That 26 V is the control voltage — not the main power — so it pulls in the contactor armature when the control circuit energises it. The coil draws 550 VA inrush at 50 Hz (cos φ 0.3) and holds at 45 VA, which tells you the control transformer needs to be sized for the inrush peak, not the sealed VA. Heat dissipation runs 12 to 16 W at 50 Hz; that's the thermal load the enclosure has to shed if the contactor is cycled hard. The coil has no built-in suppressor module, so you'll need to add a flyback diode or RC snubber across the coil terminals if the control circuit drives inductive loads or a PLC output. Without it, the inductive kick when the coil de-energises can couple noise into nearby signal wiring — check the shield first if you see phantom faults on a sensor line sharing the same panel.

Voltage tolerance and timing

The coil picks up reliably between 85% and 110% of Uc (22.1 V to 28.6 V) and drops out between 35% and 55% (9.1 V to 14.3 V) at 55 °C. That dropout margin is wide enough that a sagging 24 V control bus won't cause nuisance dropouts — the coil stays sealed until the bus dips below about 9 V. Closing time is 23 to 35 ms; opening is 5 to 15 ms, fast enough for most motor-starting and interlocking sequences.

MPN
LX1FF026