The ABB 3AXD50001195915 is an ACQ80-01-090KW-4 LV AC wall-mounted drive built for solar pump applications. It delivers 90 kW output power at 169 A under normal use, with a heavy-duty rating of 75 kW at 145 A for tougher pump loads. Input is three-phase 380-480 V, 47.5-63 Hz. The drive comes with a control unit included, so you're not sourcing a separate controller board — it's ready to commission out of the crate.
Normal-use output (Pn 90 kW, In 169 A) covers continuous pump duty at rated flow. Heavy-duty use (PhD 75 kW, IhD 145 A) handles the extra torque during startup or when the pump sees occasional overloads — sand, partial blockages, or a cold start with thick fluid. Light-overload use (PlD 90 kW, IlD 161 A) sits between the two; note the current is 161 A, not the full 169 A, so if your pump draws sustained current above 161 A, step up to the normal-use rating. The drive's apparent power output is 117 kVA, which gives you headroom for motor inrush without tripping.
Wall-mounted, frame size R7. IP21 and NEMA Type 1 enclosure — fine for indoor pump houses or sheltered outdoor locations, but not for washdown zones. If the installation sees dust or hose spray, you'll need a separate enclosure. The WEEE category is 4 (Large Equipment), so plan for end-of-life recycling compliance.
Communications and fieldbus
CAN protocol onboard, plus one RS-485 hardware interface. That's enough for Modbus RTU or a daisy-chain with other ABB drives on a CAN bus. No Ethernet port here — if you need Modbus TCP or PROFINET, you'll add an external gateway or look at the variant with the optional fieldbus module.